爱奇艺怎么扫码共享会员_青青青国产在线_xxxxx做受大片在线观看免费_外国黄色一级

產品banner

您當前的位置 : 首 頁 > 產品中心 > 日本SMC/SMC電磁閥

產品中心 Product

聯系我們Contact Us

上海乾拓貿易有限公司

電 話:021-39526589

網址:lhcdc.com

地 址:上海嘉定區嘉涌路99弄6號樓713室

SMC氣爪注意事項MHZ2-40D-M9PV

SMC氣爪注意事項MHZ2-40D-M9PV

  • 所屬分類:日本SMC/SMC電磁閥
  • 瀏覽次數:
  • 發布日期:2016-10-10
  • 產品概述
  • 性能特點
  • 技術參數

SMC氣爪注意事項MHZ2-40D-M9PV

When auto switch is set on the mounting side as shown below, allow at

least 2 mm run off space on mounting plate since the auto switch is

protruded from the gripper edge.

To set the auto switch, insert the auto switch into the auto switch

installation groove of the gripper from the direction indicated in the

following drawing. After setting the position, tighten the attached auto

switch mounting screw with a flat head watchmaker’s screwdriver.

1) To set the auto switch, insert the auto switch into the installation

groove of the cylinder as shown below and set it roughly.

(2) Insert the auto switch into the auto switch bracket installation groove.

(3) After confirming the detecting position, tighten the set screws (M2.5)

attached to the auto switch and set it.

(4) Be sure to change the detecting position in the state of (2).

? Refer to the dimension table.

? When auto switches are used, side mounting with through-holes is not possible.

Note 1) Normally open type plug position.

Note 2) Normally closed type plug position.

The plug is mounted on only one side for the single acting type.

SMC氣爪注意事項MHZ2-40D-M9PV


標簽

上一篇: SMC單向閥材質AL20-01?2016-10-10
下一篇: SMC液壓氣缸CDS1BN160-400-Z73L2016-10-10

近期瀏覽:

在線客服