SS-G01-C6S-GR-C1-31,JGH不二越疊加式直動型溢流閥

將直動型溢流閥疊加化，控制液壓

回路的較高壓力，起到安全閥的作● 使用

z 壓力調整范圍用開啟壓力表示。

企業QQ；2880626086

手機：17302157802

聯系人：劉艷

作為安全閥使用時，要使壓力過載

成分高于必需回路使用。

c 開啟壓力因油箱口背壓而異。

The superposition of the direct-acting relief valve, hydraulic control

Maximum pressure circuit, play a safety valve for use ●

z pressure adjustment range represented by the opening pressure.

x as a safety valve, to make the pressure overload

Higher than necessary circuit components use.

c opening pressure due to back pressure tank port to another.

v Because without floor and mounting bolts, so the need

Please select Press D-90~D-95 when necessary.

b 04 caliber does not drain (DR2), not

SS-G01-C6S-GR-C1-31,JGH不二越疊加式直動型溢流閥

And pressure center solenoid valve (D) with

Makes this valve stack is less than the pressure so that part of the circuit

Valve main circuit. w even if the pressure changes in the main circuit, you can make

Secondary side pressure remains unchanged after pressure adjustment.

e maximum operating pressure of 25, 35, MPa

w can be used to the maximum working pressure of 25,

35MPa {255, 357kgf / cm2} Pressure adjustment

In the range of 0.8~21, 25, 35MPa {8.2~

214, 255, 357kgf /

v 由于不含底板及安裝螺栓，所以需

要時請按D-90?D-95選定。

b 04口徑中沒有泄油口（DR2），不能

與壓力中心型電磁閥（D）配合

使這種疊加閥是使部分回路壓力于

主回路的閥。w 即使主回路的壓力變動，也可以使

調整后的2次側壓壓力保持不變。

e 較高使用壓力為25, 35, MPa

w 可以用于較高使用壓力為25，

35MPa {255, 357kgf/cm2}壓力調整

范圍為0.8?21, 25, 35MPa {8.2?

214, 255, 357kgf/

SS-G01-C6S-GR-C1-31,JGH不二越疊加式直動型溢流閥